1.中空玻璃生产线开机顺序：首先要检查中空玻璃加工设备水箱里的水充足，然后打开水泵，调整白色海绵辊上方的喷水管，保证海绵辊所有位置大多能被冲洗到。然后用手将海绵辊上的杂质和脏物清洗干净，并且保证海绵辊被完全泡开泡膨胀。注意在冬天开启中空玻璃生产线时，一定不要先打开清洗传送。因为冬天两个紧邻的海绵辊会被冻在一起，在没有被浸泡开的情况下打开传送，会导致海绵辊被撕坏。

1. Starting sequence of the insulated glass production line: First, check that the water in the water tank of the insulated glass processing equipment is sufficient. Then, turn on the water pump and adjust the water spray pipe above the white sponge roller to ensure that all positions of the sponge roller can be flushed. Then clean the impurities and dirt on the sponge roller by hand, and ensure that the sponge roller is completely bubbled and expanded. Be sure not to open the cleaning conveyor first when starting the insulated glass production line in winter. Because in winter, two adjacent sponge rollers will freeze together, opening the conveyor without being soaked can cause the sponge rollers to be torn apart.

2.然后打开清洗传送，将待加工的中空玻璃放在传送轮上，注意玻璃一定要放平稳，防止玻璃在传送过程中掉落伤到人。

2. Then turn on the cleaning conveyor and place the hollow glass to be processed on the conveyor wheel. Make sure the glass is placed steadily to prevent it from falling and injuring people during the conveying process.

3.铝隔条上涂抹的丁基胶要保证均匀，而且涂抹在整个铝条表面，防止漏胶，有毛刺现象。并且采用优良丁基胶保证铝条和玻璃结实的站合在一起。铝隔条涂完胶后禁止有粘上灰尘。

3. The butyl adhesive applied on the aluminum partition strip should be evenly distributed and applied to the entire surface of the aluminum strip to prevent glue leakage and burrs. And high-quality butyl adhesive is used to ensure that the aluminum strip and glass stand firmly together. After the aluminum partition strip is coated with glue, it is prohibited to have dust adhering to it.

4.双组份密封胶要涂抹牢固，表面保持平滑，尤其是拐角处要涂抹好，防止漏气，跑气现象。

4. Two component sealant should be applied firmly, with a smooth surface, especially at the corners, to prevent air leakage and leakage.